Sharp KB-6014LS Service Manual page 28

KB-6014LS
KB-6014LK
KB-6014LW
7. To remove the Control Panel Frame Assembly,
remove the 9 screws holding the CP frame to the C/P
angle in the back (Fig 3).
8. Unsnap the top C/P frame assembly away from the C/P
frame and unplug all wires. The C/P frame assembly is
now free.
At this point, you will have access to all parts of the Microwave Drawer.
1. Un-hook the black and white AC terminals from the Noise Filter PWB and green ground wire from the back plate.
(Fig 4).
. Attach the black and white AC terminals from the new Power Cord to the Noise Filter as shown in figure 4.
Note: The green ground wire terminal can be attached when reassembling the back plate to the drawer cavity.
Fig. 4
Un-hook/Attach Black AC Wire to Top Terminal
Noise
Filter
Unit
Un-hook/Attach White AC Wire to Bottom Terminal
Fig. 3
POWER CORD REPLACEMENT
Un-hook/Attach Ground to metal Tab on Back Plate.
8
Base plate