Installing The Thermal Module (For Vga Model) - Toshiba Satellite L630 Maintenance Manual

4.11 Thermal module

Installing the thermal module (for VGA Model)

Install the thermal Module according to the following procedures and Figures 4-15 and 4-
16.
CAUTION: When installing the cooling module, keep the following in mind:
1. Be sure to confirm the correct position for the module.
2. Secure the relevant screws on the main board according to the number sequence
sealed on the heat sink module.
NOTE: Apply silicon grease with a special syringe to cover the surface of the CPU chip
completely.
1. If silicon grease is already applied to the CPU, wipe it off with a cloth.
By using a special syringe, apply silicon grease G7762 to the CPU chip center so that
the entire CPU chip is covered with the grease G7762.
2. Install the CPU cooling module into the correct position on the system board.
3. Securing CPU cooling module with it's own screws.
4. Place the thermal module in the correct position and secure it with four screws on the
thermal module.
5. Connect the fan cable to CN4300 on the system board.
Satellite/Satellite Pro/L630/L635 Maintenance Manual
4 Replacement Procedures
4--31