Honeywell Dolphin 9500 Quick Start Manual page 10

5. The home screen appears.
Link Bar
Link
User's Guide
Setup
Current Values
Statistics
Diagnostics
Click this link to ...
Open the online help files.
Choose IP address assignments from two options:
• Obtain all IP addresses dynamically - Requests five IP
addresses from a DHCP server: one is used for the Ethernet
interface and the remaining four are assigned to each terminal
slot.
• Specify IP addresses manually - Enables you to specify IP
addresses per terminal slot and change the local USB port
(PPP) IP address.
• Run Spanning Tree Protocol (STP) - Enable or disable STP.
STP is enabled by default and helps eliminate redundancy in
the network.
Display the current values; this is the default screen.
Display the following system statistics:
• Iface - The type of interface
• Docked - Charging status
• Connect - Status of an active PPP session
• RX/TX Total - Total bytes received/transmitted
• RX/TX bps - Instantaneous bits per second
• RX/TX peak - Peak bits per second
Choose from available diagnostic options such as pinging
the network host.
8