These diagrams show minimum operating impedances for each system configuration
The XS-Series KICKER amplifiers need low impedances to make full power. In stereo mode
the amplifier will make all available power at 1/2 Ohm per channel. Likewise, 1 Ohm mono
is the impedance necessary to get full power out of the amp.
TWO CHANNEL OPERATION
In conventional stereo or two channel operation, a signal is required for each
channel and a speaker load of no less than 1/2 Ohm is connected to each of the right
and left outputs.
REMOTE TURN-ON
GROUND
FUSE
+12V
BATTERY
BRIDGED OPERATION
For bridged mono systems, an input is required to both input connectors and the speak-
er load of no less than 1 Ohms is connected to the left+ and right-.
REMOTE TURN-ON
GROUND
FUSE
+12V
BATTERY
6
SYSTEM DIAGRAMS
America's Music Machines
America's Music Machines
RCA INPUT L + R
RCA OUTPUT L + R
GAIN
ZRX MODULE
ZRX BYPASS MODULE
–
+
–
+
LEFT
RIGHT
SPEAKER(S)
SPEAKER(S)
+
+ –
–
MINIMUM LOAD IMPEDANCE
1/2Ω EACH CHANNEL
RCA INPUT L + R
RCA OUTPUT L + R
GAIN
ZRX MODULE
ZRX LOWPASS MODULE
–
+
MONO
–
+
SPEAKER(S)
+
–
MINIMUM LOAD IMPEDANCE 1Ω