Honeywell R8182D Product Data page 16

R8182D,E,F,H,J COMBINATION PROTECTORELAY™ AND HYDRONIC HEATING CONTROLS
Section 2. Composition, Information on
Ingredients (Table 3).
Ingredients
No. 2 Lithium Complex Grease (70%):
Mineral Oil
Mineral Oil
Lithium Hydrostearate/Sebacate Complex
Zinc Alkyldithiophosphate
Aluminum Paste (30%):
Aluminum, as Al
Aliphatic Petroleum Distillates
Stearic Acid
Aromatic Petroleum Distillates
a
Additional Information: Part No. 120650 (0.5 oz. tube); Part No. 107408 (4 oz. can); Part number 197007 (5 gallon container).
May also contain minute amounts of lithium and molybdenum lubricant compounds.
Section 3. Hazard Identification
Acute Health Effects:
Skin—Excessive contact can cause skin irritation and
dermatitis.
Eye—Direct contact with eye will cause irritation.
Inhalation—No adverse effects are expected.
Ingestion—Ingestion of product may cause nausea, vomiting
and diarrhea.
Chronic Health Effects:
Existing skin rash or dermatitis may be aggravated by
repeated contact.
OSHA Hazard Classifications:
None.
Carcinogenicity:
Not considered to be a carcinogen by either OSHA, NTP,
IARC, or ACGIH.
Target Organs:
None known.
Section 4. First Aid Measures
Eye Contact:
Flush eyes with water for 15 minutes. Remove any contact
lenses and continue to flush. Obtain medical attention if
irritation develops and persists.
68-0105—2
Table 2. Ingredients of Heat Conductive Compound
64742-65-0
64742-62-7
68815-49-6
68649-42-3
7429-90-5
8052-41-3
57-11-4
64742-95-6
16
CAS Number Percent
35-50
20-25
4-9
0-2
20-25
10-15
1-2
1-2
Skin Contact:
Remove excess with cloth or paper. Wash thoroughly with
mild soap and water. Obtain medical attention if irritation
develops and persists.
Ingestion:
Contact physician or local poison control center immediately.
Inhalation:
Remove patient to fresh air and obtain medical attention if
symptoms develop.
Section 5. Fire Fighting Measures
Flash Point:
>383°F (195°C). Will burn if exposed to flame.
Extinguishing Media:
Carbon dioxide, dry chemical or foam.
Special Fire Fighting Procedures:
None.
Explosion Hazards:
None. Aluminum powder can react with water to release
flammable hydrogen gas. In the form of this product, this
reaction is not expected.
Section 6. Accidental Release Measures
Scrape up and dispose as solid waste in accordance with
state and federal regulations.
Section 7. Handling and Storage
Store in dry place. Keep container closed when not in use.
a
.
PEL
3
5 mg/m 5 mg/m
3
5 mg/m 5 mg/m
— —
— —
3
15 mg/m 10 mg/m
3
2900 mg/m 525 mg/m
— —
3
5 mg/m 5 mg/m
TLV
3
3
3
3
3