Advertisement
Check these
points if tour washer...
• Unevenly distributed load. Redistribute the load, close the lid and pull knob
out. Check for leveling. Be sure water level is acceptable for load size.
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer. If
Stops
equipped with buttons, be sure they are fully depressed.
• Close lid and pull knob out to start the washer. For your safety, washer will
not agitate or spin unless lid is closed.
• This may be a pause or soak period in the cycle. Wait briefly and it may start.
• The washer is equipped with a lid switch failure detector. If the lid switch
should malfunction, the detector will stop fill operations for your safety. Call
for service.
loot
t ooo**ol
e**°°°ll,
oooo,,
e
i*****o°°1_1ooo_
o J****..°°°l,
ooot
• • o****..°°°.,
io6o_
e,***o**°°-.-°oo_
J,_**
e,**o
.-o°o,,
o,o_
o***'"
• Make sure hose connections are tight.
Leaks Water
• Make sure end of drain hose is correctly inserted and secured to drain facility.
• Avoid extended soaking - soak for 30 minutes or less.
• Avoid overloading.
• Be sure washer is leveled properly as outlined in installation manual.
Is Noisy
• Weak floors can cause vibration and walking.
• Be sure rubber feet are installed on leveling legs.
• Turn both faucets on fully.
• If equipped with a temperature selector knob, be sure it is set directly on a
Fills with
temperature setting and not between settings.
the Wrong
• Make sure temperature selection is correct.
Temperature
• Make sure hoses are connected to correct faucets and inlet connections.
Be
Water
sure water supply is regulated correctly.
Flush water line before filling
washer.
• Check the water heater. It should be set to deliver a minimum 120°F (49°C)
hot water at the tap. Also check water heater capacity and recovery rate.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
Cycle Selector
Knob Advances
• Extra rinse option is selected
Through "OFF"
For further help, call Maytag Customer Assistance: U.S. 1-800-688-9900 or Canada 1-800-688-2002
10
Advertisement
