Advertisement
Before You Call ...................................................
For problem laundry solutions (i.e. fabric damage, residue, tangling) and special laundry care proce-
dures, see the enclosed Laundry IYpspamphlet.
Check
these
)oints if your wash, r...
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer.
Won't Fill
If equipped with buttons, be sure they are fully depressed.
• Turn both faucets on fully.
• Straighten inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
o, °°o*
e e or.°.
J*ooQ,
e°*o
e,t*.,
°.o
e _*t
°°,**,
eot
o,,**,
e**_o,**_
eot
t o,*t*_*°,,,*****°°,**o*o*°e,
J****
°°°e,****°°,
e _***
°°*
• w_t**
t*t
o,*
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer.
If equipped with buttons, be sure they are fully depressed.
Won'tAgitate
• Close lid and pull knob out to start the washer. For your safety, washer will
not agitate or spin unless the lid is closed.
• The washer is equipped with a lid switch failure detector.
If the lid switch
should malfunction, the detector will stop operations for your safety. Call for
service.
..°,,
e*t,o°.
I***
Q°°°*,
e.t*°
°, .o e o*.o,
..o_
e*°°,
I*_o
o,°°,,.o_
e*°°l***_
e*°*,*,,,
e*°e,*t,**
°o* Q_,*,*°*,
• _*,
J°o*e
o*,*.
1.o
• _l,.i**_
_*,°
• Unevenly distributed load. Redistribute the load, close the lid and pull knob
out. Check for leveling. Be sure water level is acceptable for load size.
• Check fuse or reset circuit breaker.
• Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction,
call for service.
Won't Spin
• Close lid and pull knob out to start the washer. For your safety, washer will
or Drain
not agitate or spin unless the lid is closed.
• Suds lock - caused by too much suds. Rewash without detergent. Use cor-
rect amount of a low-sudsing detergent.
• The washer is equipped with a lid switch failure detector. If the lid switch
should malfunction, the detector will stop operations for your safety. Call for
service.
9
Advertisement
