Yealink SIP-T32G Quick Installation Manual

1. Press the key when the phone is idle to get the IP address of your phone.
2. Open the Web browser of your computer, enter the IP address into the address bar (e.g.
"http://192.168.0.10" or "192.168.0.10") and click
3. Enter the user name (default: admin) and password (default: admin) in the pop-up dialogue
box and click .
Please locate your computer in the same network segment of the IP phone (192.168.0.X) to access the
Web user interface. Contact your system administrator for more information.
Click on ->
You can configure the network settings in the following ways:
: By default, the phone attempts to contact a DHCP server in your network in order to obtain
its valid network settings, e.g. IP address, subnet mask, gateway, DNS server.
: If your phone can not contact a DHCP server for any reason, you need to
configure IP address, subnet mask, default gateway, primary DNS and secondary
DNS for the phone manually.
: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE
mode. Contact the ITSP for the account and password.
The wrong network settings may result in inaccessibility of your phone and may have an impact on the
network performance. Contact your system administrator for more information.
Click on ->
It shows the register status of the current account.
Register Status:
You can select Enabled/Disabled to enable/disable the account.
Account Active:
It is shown on the LCD to identify the account.
Label:
It is shown as Caller ID when placing a call.
Name:
It is provided by ITSP for registration (required).
User Name:
It is authenticated ID for authentication provided by ITSP (required).
Register Name:
It is provided by ITSP for registration (required).
Password:
It is provided by ITSP for registration (required).
SIP Server:
Registered Register Fail
Check with your system administrator if any error appears during the registration process or if a specific
configuration is required for your registration.
Press the soft key when the phone is idle, select
-> ->
Press the soft key when the phone is idle, select
-> to configure the account settings.
Refer to
For more information, refer to the User Guide available online:
c
Copyright 2014 YEALINK NETWORK TECHNOLOGY CO.,LTD.
.
->
(X=1,2,3)
Registering
->
to configure the network settings.
->
for the parameter informantion.
www.yealink.com
(V70.3)