Mechanical Instructions - Philips A02U AA Service Manual

EN 8 4.

4. Mechanical Instructions

Index of this chapter:
1. Service connector
2. Set Disassembly
3. Service Positions
4. Assies / Panels Removal
5. Set Reassembly
Note: figures below can deviate slightly from the actual
situation, due to the different set executions.
4.1
Service Connector (for ComPair)
For service diagnostics with ComPair, it is not necessary to
disassemble the set. You only have to connect the ComPair
interface box via the appropriate cable, to the service
connector on the rear of the set (see figure "Rear connections"
in chapter "Technical specifications, ..."), and start the program
(see also chapter "Service Modes .... ").
4.2
Set Disassembly
Follow the disassemble instructions in described order.
4.2.1
Rear Cover Removal
Warning: disconnect the mains power cord before you remove
the rear cover.
For PV2 styling (for 8402 and 8302 sets)
1. Manually unlock and remove the two plastic cover cups (1)
(if present) on the top of TV.
2. Remove all the fixation screws of the rear cover.
3. Remove the rear cover.
Figure 4-1 Rear cover (for PV2 styling)
For FL13 styling (for 8502 sets)
1. Remove all screws. If you do not remove them, you cannot
access the clips.
2. Tilt the set a little forward, so that you can release the two
clickfit clamps that are located at the bottomplate of the set.
3. Four openings (1) can be found at the top. The openings
are very small (2).
Note: Some sets only have the two inner openings.
4. Underneath every opening there is a clip. Push this clip
down with a very thin piece of metal (3), until you hear a
click.
Caution: do not use a screwdriver, this will damage the
cabinet.
5. When all four clips are pushed down, the back cover can
be removed.
A02U AA Mechanical Instructions
1
E_13950_010.eps
Figure 4-2 Rear cover (for FL13 styling)
030304
1
Figure 4-3 Opening
Figure 4-4 Pushing clips down
E_13950_011 .eps
030304
2
E_13950_012 .eps
100304
3
E_13950_013.eps
030304