How To Clean Filter; How To Clean And Remove The Aerator; How To Convert Rigid Goose Neck Spout To Swing Spout - American Standard Selectronic Proximity Faucet Installation Instructions Manual

HOW TO CLEAN FILTER; Fig. 4
4
Before opening ENCLOSURE
CAUTION
disconnect AC power supply.
1. Remove ENCLOSURE COVER.
2. Close SUPPLY STOP (5) with 4mm Hex wrench.
Note: Keep water flowing out of faucet while shutting off.
3. Pull off Red (1) and Black (2) CONNECTORS from
SOLENOID VALVE (3).
4. Unthread STRAINER (4) using a 7/16" socket.
5. Pull out the STRAINER (4) and clean with an old
toothbrush. Rinse thoroughly with water.
6. Install the STRAINER (4) back in its place and
tighten with a 7/16" socket.
Caution: do not over tighten strainer.
Note: It is recommended to clean strainer every 6
months.
7. Replace ENCLOSURE COVER. Tighten cover
screws firmly.
5
HOW TO CLEAN AND REMOVE
THE AERATOR; Fig. 5
1. Remove AERATOR HOUSING (1) with KEY
supplied with faucet.
3. Remove AERATOR (2) from HOUSING (1).
2. Clean the AERATOR SCREENS (3) with a old tooth
brush to remove dirt.
4. Rinse Clean with water. Reassemble and install into
spout end. Be sure black seal washer is in place.
HOW TO CONVERT RIGID GOOSE
6
NECK SPOUT TO SWING SPOUT
Fig. 6
The GN SPOUT is shipped from the factory as a
rigid assembly. To convert the GN SPOUT into a
SWING SPOUT proceed as follows:
1. Remove SET SCREW (1) from back of GN SPOUT
(2) with a flat blade screwdriver. Fig. 6.
2. Install SWIVEL SET SCREW (3) into opening in the
GN SPOUT (2). SWIVEL SET SCREW (3) is found in
hardware bag within product box.
Fig.4
2
5
1
Fig.5
Fig.5
Fig.6
2
1
8
3
4
CLEAN
SCREENS
4
3
1
2
3
(USE SHORT
SET SCREW
FOR SWIVEL
SPOUT)