Related Manuals for Scotsman SCCG30
Summary of Contents for Scotsman SCCG30
- Page 1 Installation and User's Manual for Residential Ice Machine Models SCCG30 and SCCP30...
-
Page 2: Table Of Contents
SCCG30 & SCCP30 User Manual Introduction: This ice machine is the result of Scotsman’s decades of experience in the design and manufacturing of both commercial and residential ice machines. This manual includes the information needed to install, start up and maintain the ice machine. Note any Caution or Warning indicators, as they provide notice of potential hazards. -
Page 3: Specifications
Use outside of the listed limitations is misuse and will void the warranty. Door Panel kits:Finished door panels are available from Scotsman for attachment to the machine, or a Air temperature limits custom panel can be made. -
Page 4: Cabinet Layout
SCCG30 & SCCP30 User Manual Cabinet Layout FLOOR DRAIN 3 7/8" ACCESS HOLE 20 3/8" 22" .75 SHEET METAL DOOR FRONT 14 7/8" .63 MIN. CABINET DOOR 29 1/4" 33 3/8" MIN. 34 3/8" MAX. DRAIN FLEXIBLE TUBING 3/8 I.D. PUMP MODEL (INCLUDED) 5/8 I.D. -
Page 5: Air Flow
They meet or exceed the standards of agencies like U.L. Scotsman assumes no liability or responsibility of any kind for products manufactured by Scotsman that have been altered in any way, including the use of any parts and/or other components not specifically approved by Scotsman. -
Page 6: Water Quality
To keep the machine operating properly, these impurities or minerals will have to be regularly dissolved by an acid cleaning, using Scotsman Ice Scale Remover. Directions for this may be found in the section under cleaning. -
Page 7: Door Panel
Door Panel Attachment See instructions in information packet to create and attach a custom panel: To attach a Scotsman supplied panel: Note: If door swing is to be changed, it must be done before panel is attached. The panel will be held on by 6 sheet metal screws and 2 machine screws. -
Page 8: Door Panel Attachment
SCCG30 & SCCP30 User Manual Door Panel Attachment Use Upper Hole at the Scotsman Door Panel Gasket Machine Screw Hole Plug Use Lower Hole at the Bottom Cover November 2009 Page 8... -
Page 9: Door Swing Change
SCCG30 & SCCP30 User Manual Door swing change The door can be attached to open with hinges on 8. Replace the bracket with the one supplied the left or right using new hinge brackets shipped loose with the machine. Secure it using the loose in the ice bin. -
Page 10: Water
SCCG30 & SCCP30 User Manual Water The recommended water supply tubing is ¼ inch 3. Install a compression fitting on the tubing and OD copper. Stainless steel flex or reinforced PVC connect to the inlet of the solenoid. tube may also be used. Install an easily accessible shut-off valve between the supply and the unit. -
Page 11: Gravity Drain
SCCG30 & SCCP30 User Manual Gravity Drain Caution: Restrictions in the drain system to the 5. Cut an 8” piece of 5/8” ID X 7/8” OD tygon (clear machine will cause water to back up into the ice plastic) tubing. Slide one end of the tube onto the storage bin and melt the ice. -
Page 12: Electrical
SCCG30 & SCCP30 User Manual Electrical The ice machine is supplied with a power cord. Do Initial Start Up not remove the grounding pin from the cord’s plug. Do not use extension cords. Follow all codes. 1. Turn on the water supply. -
Page 13: Use
SCCG30 & SCCP30 User Manual No special instructions are needed for use. Just Maintenance take as much ice as you need, the machine will replace it. A scoop is provided, and it can be stored There are 5 things to keep clean: in the machine using the loop of tubing on the right side as a holder. -
Page 14: How To Clean The Condenser
1. Remove the kickplate. it in a ice chest or cooler. 2. Locate the condenser surface. 2. Pour 8 ounces of Scotsman Ice Machine Scale Remover (available from a local Scotsman 3. Vacuum the surface, removing all dust and lint. - Page 15 SCOTSMAN ICE SYSTEMS 775 Corporate Woods Parkway, Vernon Hills, IL 60061 800-533-6006 www.scotsman-ice.com 17-3191-01...