NetComm NP290W Quick Start Manual
  1. Manuals
  2. Brands
  3. NetComm Manuals
  4. Network Accessory
  5. NP290W
  6. Quick start manual
NetComm NP290W Quick Start Manual

NetComm NP290W Quick Start Manual

Turbo wireless homeplug
Hide thumbs Also See for NP290W:
Table of Contents

Advertisement

Quick Links

Download this manual See also: User Manual
Quick Start Guide
NP290W
Turbo Wireless HomePlug

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NP290W and is the answer not in the manual?

Questions and answers

Related Manuals for NetComm NP290W

Summary of Contents for NetComm NP290W

  • Page 1 Quick Start Guide NP290W Turbo Wireless HomePlug...

  • Page 2: Table Of Contents

    Minimum Requirements ......................3 Typical NP290W Turbo Wireless HomePlug Connection ............. 3 Package Contents ........................3 Chapter 2 – NP290W Turbo Wireless HomePlug Overview ..............4 Light Indicators and Ports ......................4 Chapter 3 – Hardware Installation ...................... 5 Connecting with a computer ....................5 Connecting with an existing network/router ................

  • Page 3: Chapter 1 – Introduction

    Chapter 1 – Introduction The NP290W Turbo Wireless HomePlug is a 85Mbps Adaptor with 802.11G Wireless LAN that transforms your in-house power circuit into networking infrastructure with a Wireless LAN interface. The NP290W is ideal for anyone wishing to extend their Wireless Internet access or make an internal network. Surf the Internet, share data, and rest assured that your privacy is safe through the security encryption on the power circuit and WLAN.

  • Page 4: Chapter 2 – Np290W Turbo Wireless Homeplug Overview

    (RJ-45) to connect to your Ethernet Network card or Ethernet Router/Modem or Ethernet Hub/Switch. The Reset button is used to reset the NP290W Turbo Wireless HomePlug to its factory defaults. To reset the NP290W Turbo Wireless HomePlug, simply press the reset button for about 5 seconds.

  • Page 5: Chapter 3 – Hardware Installation

    To connect the HomePlug Wireless Adapter with a computer: Insert one end of an Ethernet cable from the computer’s Ethernet port, then insert the other end into the HomePlug’s Ethernet port. Note: When setting up the HomePlug Wireless Adapter with a computer, you have to set NP290W the static IP Address in the computer’s network card. For instructions, please refer NP290W to Configuring TCP/IP. 2. Plug the HomePlug Wireless Adapter into the electrical outlet.

  • Page 6: Chapter 4 – Using The Cd Setup Utility

    Chapter 4 – Using the CD Setup Utility The CD Setup Utility provides easy to follow step-by-step instructions to help you change the wireless network name and wireless security settings. It opens on Windows operating systems. Note: Using the CD Setup Utility is optional. Right out of the box, you can already use your HomePlug Wireless Adapter. To use the CD Setup Utility: 1.

  • Page 7: Configuring Tcp/Ip

    Configuring TCP/IP Here are instructions on how to manually configure TCP/IP on a Windows operating system. You need to set the TCP/IP settings manually to access the Web User Interface and to allow your computer and HomePlug Wireless Adapter to communicate with each other. Notes: If you are using a non-Windows operating system, please refer to the operating system’s documentation about how to change the TCP/IP settings.
  • Page 8 NP90W Quick Start Guide YML848Rev 1...

Table of Contents