Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for PrimeAire PA7010E
- Page 1 Model: PA7010E & PA5010E 770-821-6204...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Dehumidi er Safety Installation Requirements Electrical Requirements Location Requirements Dehumidi er Use Setting the Controls Draining the Dehumidi er Normal Sounds Dehumidi er Care Cleaning the Air Filter Cleaning the Dehumidi er Troubleshooting... -
Page 3: Dehumidi Er Safety
DEHUMIDIFIER SAFETY Your safety and safety of others are very important We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER”... -
Page 4: Location Requirements
Location Requirments NOTE: Your model may di er from the one shown. Allow at least 12” to 18” (30.5 cm to 45.7 cm) of airspace on the side of the dehumidi er for models with side louvers and above the dehumidi er for models with top louvers. You will need a surface strong enough to support the dehumidi er when its bucket is full of water. -
Page 5: Setting The Controls
Auto Dry - Will operate the dehumidi er only in the dry mode. Auto Fan Speed is set automatically. The desired humidity is set to 50% automatically. Continuous - Will operate the dehumidi er continuously. The Fan Speed can be adjusted. The Desired Humidity cannot be adjusted. -
Page 7: Draining The Dehumidi Er
If you plan to run your dehumidi er continuously, you may want to attach a garden hose to the drain hose connector. Turn the connector cover counter clockwise to remove it. -
Page 10: Cleaning The Air Filter
Cleaning the air filter Cleaning the dehumidifier... -
Page 11: Troubleshooting
TROUBLESHOOTING All models have an automatic deicer that will Is the dehumidi er turned on? shut o the compressor and allow the fan to Turn on the dehumidi er. run. This reduces the ice buildup on the coils. The compressor will cycle back on when the deicer senses the correct operating temperature.