LG WD-8050F Service Manual page 61

PUMP
Screw
Cap
(Remaining Hose)
HEATER
THERMISTOR
Pump Outlet Hose
Tub Pump Bellows
¤ Remove pump outlet hose.
¤ŁRemove tub pump bellows.
¤ØRemove cap(Remaining Hose.)
¤ŒDisconnect the wiring.
¤ºUnscrew 3 screws
¤ Remove the pump.
¤ Unscrew 3 screws fixing the heater protecting cover.
¤ŁLoosen the M6 heater nut to pull out the heater.
CAUTION
When mounting the heater, be sure to insert the heater
into the heater clip on the bottom of the tub.
¤ Pull it out by holding the thermistor bracket.
ƒTIf it is pulled by the wire, it may be broken.
¤ŁWhen mounting the thermistor again, make sure that it
is got back tight to the rubber.
29