Advertisement
Save your creation
Once you've customized a program, you'll want to save it! Here's how:
•
While in either EDIT 1 or EDIT 2 mode, press the WRITE button.
•
Turn the VALUE knob to select a program number (you can't save the preset locations, P00-P99)
•
Press the WRITE button again.
The program will be saved, and you'll be returned to Live mode.
Note: To restore the Wavedrum's factory programs, hold down the WRITE button while turning the Wavedrum on. The
display will blink "Pld." Press and hold the WRITE button for one more second, and the factory programs will be restored.
When the display shows "End," turn the Wavedrum off and then back on again.
Calibrate the Wavedrum
Wavedrum offers multiple calibrations to suit your playing requirements.
Hold down the BANK/MODE button, and press button 4 to enter Global mode.
Press the BANK/MODE button to cycle through these pages:
•
Com- Common settings, including panning, AUX IN mix level, and loop playback.
•
H.ca- Head calibration-
- Button 1 (Lo) modifies low attenuation threshold.
- Button 2 (SEn) modifies sensitivity.
•
R.ca- Rim calibration
- Button 1 (Lo) modifies low attenuation threshold.
- Button 2 (SEn) modifies sensitivity.
•
P.ca- Pressure calibration
- Button 1 (VaL) shows the pressure value.
- Button 2 (P.Lo) specifies the minimum detected pressure.
- Button 3 (P.Hi) specifies the maximum detected pressure.
Once you select the parameter you want to change,
turn the VALUE knob to modify it.
After you're finished making changes, press the WRITE button
to save the Global settings.
For more information, please visit http://www.korg.com/wavedrum
Advertisement
