Overview; How To Use The Ws-Gpib; (A) Connection - LeCroy WS-GPIB User Manual

Overview

Connecting the WaveSurfer and a PC equipped with a GP-IB interface
using the WS-GPIB allows you to control the WaveSurfer via the GP-IB.
The GP-IB connector conforms to IEEE488.2 standard. Its delimiter
setting is LF+EOI. The USB connector conforms to USB 2.0.
For details of the GP-IB commands, see the Remote Control Manual in
the User's Manual CD supplied with the WaveSurfer.
Note that the WS-GPIB does not functions as a controller.
Make sure to thoroughly read this manual and have a good understanding
of the GP-IB prior to using it.

How to Use the WS-GPIB

Use the WS-GPIB following the steps shown below.

(a) Connection

As shown in Figure 1 below, connect the USB connector of the
WS-GPIB to the USB port of the WaveSurfer, then connect the other end,
the GP-IB connector, to that of the PC.
NOTE: During this operation, keep the power button of the
ＷaveSurfer
Figure 1 Connection Diagram of GP-IB Control
WaveSurfer,the PC in the OFF state.
WS-GPIB
USB port
GP-IB
connector
Desktop or
notebook PC