Advertisement
The Helicopter
Charging port
Camera
The Remote Control
Battery indicator light
Throttle stick
Landing light ON/OFF
2
Upper Rotors
Lower Rotors
Micro-SD card slot
Power ON/OFF
Antenna mount
Video Record button
Flight stick
Tail Rotor Speed Control
Power switch
Trim control
Troubleshooting
Cannot control the chopper
Tail rotor
Helicopter will not ascend.
Helicopter lands too fast
Charging time
Flying time
Control distance
Frequency
Battery (helicopter)
Battery (remote control)
•
Ensure the controller is switched ON.
•
Ensure the helicopter is switched ON.
•
Try pairing the remote and the helicopter again.
•
Check the batteries in the remote and if needed,
replace with new batteries.
•
Ensure the antenna is securely attached to the
remote.
•
Ensure the helicopter is fully charged.
•
Do not fl y the helicopter in high winds as this may
make it hard to control.
•
Center the trim control and if needed, adjust the
trim again.
•
The charge in the helicopter may be too low. You
will need to recharge the helicopter.
•
Check that you are providing enough throttle to
lift the chopper.
•
You are reducing the throttle too fast. Reduce the
throttle gently to get a gradual descent to the
ground and a softer landing.
Specifi cations
Approx. 60-70 minutes
Approx. 5-8 minutes
Approx. 20-30m / 65ft - 98ft
27MHz
DC 3.7V output (580MA)
AA 1.5V x 6 (not included)
11
Advertisement
