Rubber Grip; Sd Memory Card; Antenna Rotation; Receiver Information - Spektrum DX3C Instruction Manual

Rubber Grip

This transmitter includes 3 sizes of grips and the medium-size grip is installed at the factory. Inside the grip is a letter showing size:
L for large, M for medium and S for small.
Remove the grip by lifting the edge of the grip and pulling the grip away from the handle. Install a grip by aligning grip tabs with
handle slots and pressing the grip in place.

SD Memory Card

an SD card. To upload new software to your DX3C transmitter:
1. Remove the grip from the back of the transmitter handle.
card reader port.
3. Power on your transmitter.
will fill until upload of software is complete.
7. The transmitter is updated and ready for use.

ANTENNA ROTATION

Turn and bend the antenna at its hinge to point the tip of the antenna away from the
model. The strongest signal of the transmitter comes from the shaft of the antenna,
not the tip.
WARNING: Do not pick up the transmitter by the
antenna. Do not alter or put weight on the antenna.
Damage to antenna parts can decrease transmitter signal
strength, which can result in loss of model control, injury or
property damage.

RECEIVER INFORMATION

See www.spektrumrc.com for all compatible receivers.

Receiver Connection and Installation

Install the receiver using double-stick tape in the typical electric-powered model on the side opposite from the ESC.
Install the receiver using double-stick tape in the typical gas-powered model as far forward of the motor as possible.
best reception of the transmitter signal.
-
EN
5