Kenwood TK-2200 Service Manual page 7

3. Attaching the antenna receptacle to the
chassis.
Screw the antenna receptacle to the chassis in the order
shown in the drawing so that the antenna receptacle comes
to the center of the case hole.
Tighten this screw first.
Tighten this screw second.
4. The nuts of the volume knob and channel
knob
Note that the shapes, colors and heights of nuts of the
volume knob and channel knob are different from one
another. (The nut of volume knob is silver, and the nut of
channel knob is gold)
Use the following jig when removing the nuts of the
volume knob and channel knob.
Jig (Part No. : W05-1012-00)
●
Volume Knob
(Silver)
DISASSEMBLY FOR REPAIR
Channel Knob
(Gold)
5. Connecting the speaker wires to the TX-RX
unit
Note: To connect the speaker wires, you must solder it to the
location of the TX-RX unit as illustrated below.
TK-2200
SP–
SP+
TX-RX UNIT
Component side view
7