Advertisement
•
CAUTION
i Do not move the unit while someone is sitting on it. Do not place objects on or sit, climb, or stand
on the calfrest.
Lifting and Moving the Unit
• Always use two persons to lift the unit. Use one person on
the left and one person on the right to hold underneath the
armrests to carefully move the unit, see the picture below.
• Hold onto to the armrest tightly to prevent damage to the unit and the floor
The following sounds are perfectly normal and will not have any
effect on the operation of the unit:
• Sound of the armrest and back cushion rubbing against other objects during recline
• Sound of Tapping.
• Sound when the unit is at Standby Mode by flipping the Power Switch to "On" .
• Sound when sitting down.
• Sound of air being pumped in during an Air Pressure Massage.
• Sound of air being released during an Air Pressure Massage.
• Deep Vibration sounds during Vibration Massage
• Rattling sound of the calfrest.
M
Problem
Problem
Networking when
plugged in.
The unit makes a humming
sound or clip clop clip clop
noise during operation.
You may notice an increase
in noise during a session.
The unit stops working suddenly
Possible Reasons
Solutions
-The power switch is off.
-Turn on the power switch.
-The lock switch is off.
-Turn on the lock switch.
-Power plug is not properly connected -Reconnect the power plug
with the outlet.
-The fuse is blown.
with the
°
ut|
et.
-Replace the fuse with
the same specifications.
Sounds are made bytheairpump,
the electrical parts and the
mechanical parts.
The sounds are normal. No need
for maintenance.
The unit has been used over its
Shut down the unit and turn it
time limit.
back on after a half an hour.
Time out.
Shut down the unit and turn it back
onaftera half an hour.
Advertisement
