Advertisement
I
Adjusting the Calfrest and Backrest
1-Turn the unit onto the Standby Mode by plugging in the Power Plug,
turning on the Lock Switch and the Power Switch.
2-Press
to adjust the angle of the backrest and calfrest.
Adjusting the Pillow Position
• Always unplug the unit before cleaning it. Never touch
a power plug with wet hands.
-Failure to follow these instructions may lead to electrocution or burns.
Cleaning The Upholstery
• Wipe these areas with a soft, dry cloth. (Do NOT use cloths containing any kind of chemical, etc).
• If the upholstery is particularly dirty, please:
1 .Soak a soft cloth in water or a 3% - 5% solution of mild detergent, wring it out thoroughly;
2.Wipe the surface with the wetted cloth;
3.Next, rinse the cloth in water, wring it out thoroughly and then wipe any remaining
detergent from the surface;
4.Wipe the surfaces with a soft dry cloth;
S.AIlow them to dry naturally. (Do NOT use a hair dryer to dry the surfaces).
• Do not allow these areas to get in touch with plastic for extended periods of time as it may lead to discoloration.
• Please do NOT use paint thinners, benzene, or alcohol to clean the surface.
Cleaning Remote Panel, Wood Chair Back and Swivel Base
• Wipe the unit with a cloth that has been soaked in a mild detergent and thoroughly wrung
out.
• Next, wipe the unit with a cloth that has been moistened with water only and thoroughly
wrung out.
• Make sure you thoroughly wring out the cloth first when cleaning the control panel.
• Allow the unit to dry naturally.
• Please do NOT use thinners, benzene or alcohol to clean the surface.
Advertisement
