Table of Contents
Advertisement
WM60 TRANSMITTER
Front Panel
.
Sig/Clip Indicator– the LED indica-
tor will light up green when a signal
is being received by the WM60 trans-
mitter. It will turn red when the signal
level becomes excessive, just 4dB
before clipping.
.
Channel Selector– adjusting this dial
to one of the preset channels allows
the WM60 to know which frequency
to send the wireless information at.
The wireless receiver should be set
to the identical channel if transmis-
sion is to occur successfully.
3.
On/Off Button– this button turns the
WM60 on and off.
Antenna– this is the WM60's an-
4.
tenna. Adjust it so it sits in a vertical
position when the device is in use
(change the position if the wireless
signal quality is poor). Push the an-
tenna in to release it before adjusting
its position.
4
SIG/CLIP
1
8
WM60
WIRELESS T RANSMITTER
ON
OFF
2
3
Rear Panel
5.
1/4" Input– this jack accepts bal-
anced and unbalanced /4" inputs
from line-level sources.
6.
XLR Input– this jack accepts bal-
anced XLR inputs from line-level
sources. Both the /4" jack and the
XLR jack run in parallel.
7.
DC In– plug DC end of the supplied
DC power adaptor into this jack, and
the other end into a suitable AC pow-
er source to allow the WM60 to be
powered. Please ensure you use the
DC power supply (V, 750mA) pro-
vided with this unit, as using another
power supply could cause damage.
7
5
DC IN
INPUT
WM-SYS3 / WM-SYS3D / WM-SYS4 / WM-SYS4D
6
Advertisement
Table of Contents
