Replacement Parts; Optional Accessories; Statement Of Conformity; General Information - Shure M367 User Manual

REPLACEMENT PARTS

Foot Kit (4 in kit) . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
M367 Fuse, 0.125 A, 250 V
M367E Fuse, 0.063 A, 250 V
Knob
Master . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Channel Gain, Phones . . . . . . . . . . . . . . . . . . . . . . .
Line (Power) Cord
M367 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
M367E . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

OPTIONAL ACCESSORIES

Rack Mount Kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

STATEMENT OF CONFORMITY

This certifies that the Shure M367E Microphone Mixer meets the
specifications and regulations embodied in Vfg 243/1991,
amended 1992. The Bundesamt für Zulassungen in der Telekom-
munikation has been notified that this device has been marketed
and has been provided the right to verify the device or system for
compliance with the specifications.
Conforms to European Union directives, eligible to bear CE mark-
ing; VDE GS-Certified to EN 60 950; meets European Union EMC
Immunity Requirements (EN 50 082–1, 1992): RF radiated (IEC
801–3): meets Criterion A, ESD: meets Criterion B, EFT (IEC
801–4): meets Criterion B.
6
90S8100
. . . . . . . . . . . . . . . . . . . . . . 80E380
. . . . . . . . . . . . . . . . . . . . 80G380
95A8238
95B8238
95A8389
95B8389
A367R

GENERAL INFORMATION

Changes or modifications not expressly approved by Shure, Inc.
could void your authority to operate this equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15 of the FCC
Rules and as set out in the Radio Interference Regulations of the
Canadian Department of Communications. These limits are
designed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment causes harmful
interference to radio or television reception, determined by
turning the equipment off and on, try to correct the interference by
one or more of the following measures:
1.Reorient or relocate the receiving antenna.
2.Increase the separation between the equipment and receiver.
3.Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
4.Consult the dealer or an experienced radio/TV technician for
help.