Table of Contents
Advertisement
2.4G Digital Wireless Audio Transceiver Module SOYO-WM24G02
2.3.
Receiver Module
Arrangement
2.3.1Approaches of Pairing Point to Point
Pairing point to point:
Simultaneously press the CH+ buttons of both Receiver Module module and Transmitter module for more
than 3s( during which LED is continuously out for 3s) till LED is on. The moment you release it, it gets into the
5-second-point-to point-ID-pairing state(during which LED is flickering).
Receiver Module Paring Arrangement
When Receiver Module receives paired signals, the LED of the receiver flickers three times,
indicating that it gets into the receiving state, waiting for signals from the transmitter. Normally, the
LED will be out when paring is fulfilled.
Transmitter Module Paring Arrangement
When the CH button of the transmitter module is released, its LED flickers five times. When
pairing is fulfilled, the LED of the receiver module is out.
Approaches of Pairing Point to Mass:
2.3.2
Transmitter Module using methods
Press the
CH button of the receiver for more than 3s (during which the LED is continuously out for 3s)
till the LED is on. The moment you release it, it gets into the 5s-point-to-point-ID-pairing state (during which
the LED flickers). If you again press the button while it is flickering, its continuous flickering indicates that the
module gets into the state of pairing point to mass. The button should not to be released until the pairing work is
done.
Receiver Module using methods
When the transmitter module has got into the state of pairing point to mass, press the CH button of the
http://www.chinasoyo.com
SOYO TECHNOLOGY DEVELOPMENT CO.,LTD.
and Transmitter Module Pairing
12
Page
of 13
Advertisement
Table of Contents
