Check The Safety System; Removing The Cutting Unit - Husqvarna Rider Battery Operator's Manual

Check the safety system

The machine is equipped with a safety system that prevents
starting or driving under the following conditions.
The machine can only be started when:
• The parking brake is depressed and the operator sits on
the seat.
The engine must stop when:
• The cutting deck is lowered and the driver rises from the
seat.
• The cutting deck is in its raised position, the parking brake
is not applied and the driver rises from the seat.
Check daily to ensure that the safety system works by
attempting to start the engine when one of the conditions
above is not met. Change the conditions and try again.

Removing the cutting unit

The cutting deck can be removed in order to facilitate cleaning
and servicing.
To remove the cutting deck proceed as follows:
1 Position the machine on flat ground.
2 Turn off the machine and remove the ignition key.
3 Apply and lock the parking brake.
4 Check that the lever for setting the cutting height is in the
S position.
5 Lower the cutting unit.
6 Loosen the snap lock for the covers on the cutting deck
and loosen the cables. There are 2 for each motor.
Maintenance
7 Grasp the upper pipe framework in the cutting deck and
the cutting deck lock at the same time, and pull out the
cutting deck.
8 Lift off the deck and lean it against the machine or a wall.
Fitting the cutting head
1 Push the cutting deck in and make sure the guide bolts fit
into the grooves on the deck frame, one on each side.
2 Fit the cutting deck's pipe together with the deck frame's
pipe.
3 Press in the lock, grasp the pipes and slide in the cutting
deck.
4 Push the deck until you feel the pipes touch bottom.
– 19
English