Setting Cruise Control; Resuming A Set Speed; Increasing Speed While Using Cruise Control - GMC 2014 Terrain Owner's Manual

9-36 Driving and Operating
ON/OFF CRUISE: Press to turn
the cruise control system on and off.
CANCEL: Press to disengage
cruise control without erasing the
set speed from memory.
RES/+ (Resume/Accel): Move the
thumbwheel up briefly to make the
vehicle resume to a previously set
speed or hold upward to accelerate.
If cruise control is already active,
use to increase vehicle speed.
SET/ (Set/Coast): Move the
thumbwheel down briefly to set the
speed and activate cruise control.
If cruise control is already active,
use to decrease speed.

Setting Cruise Control

If the cruise button is on when not in
use, it could get bumped and go into
cruise when not desired. Keep the
cruise button turned off when cruise
control is not being used.
1. Press ON/OFF CRUISE.
2. Get to the speed desired.
3. Move the thumbwheel toward
SET/ and release it. The
desired set speed briefly
appears in the Driver Information
Center (DIC) display.
4. Remove foot from the
accelerator.

Resuming a Set Speed

If the cruise control is set at a
desired speed and then the brakes
are applied, the cruise control is
disengaged without erasing the set
speed from memory.
Once the vehicle reaches about
40 km/h (25 mph) or more, move the
thumbwheel up toward RES/+
briefly. The vehicle returns to the
previously set speed.
Increasing Speed While Using
Cruise Control
If the cruise control system is
already activated,
Move the thumbwheel up toward
RES/+ and hold it until the
vehicle accelerates to the
desired speed, and then
release it.