Table of Contents
Advertisement
Main Menu
Table of Contents
7.
If the expansion tank needs
coolant, you will have to remove
the cap. Before doing that, turn
the ignition switch to ON (II), and
check the temperature gauge.
Remove the expansion tank cap
ONLY if the temperature gauge
pointer has come down to normal
or below, and you do not hear any
bubbling or gurgling noises
coming from the cooling system.
Removing the expansion tank
cap while the engine is hot can
cause the coolant to spray out,
seriously scalding you.
Always let the engine and
radiator cool down before
removing the expansion tank
cap.
8.
Using gloves or large heavy cloth,
turn the expansion tank cap one-
quarter turn counterclockwise
without pushing down. After the
pressure releases, push down on
the cap, and turn it until it comes
off.
9.
Start the engine, and set the
temperature control dial to
maximum heat. Add coolant up to
the MAX line on the expansion
tank. If you do not have the proper
coolant mixture available, you can
add plain water. Remember to
have the cooling system drained
and refilled with the proper
mixture as soon as you can.
10.
Put the expansion tank cap back
on tightly. Run the engine, and
watch the temperature gauge. If it
goes back to the red mark, the
engine needs repair (see
on page
Emergency Towing
If the Engine Overheats
11.
If the temperature stays normal,
check the coolant level in the
expansion tank. If it has gone
down, add coolant to the MAX
mark. Put the expansion tank cap
back on tightly.
197
).
189
Advertisement
Chapters
Table of Contents
