Source Effects Settings - Creative audigy 5 User Manual

Source Effects Settings

The Source tab allows you to set the amount of the effects to apply on an audio source.
Changing the Amount of the Effects for an audio source
1. On Sound Blaster Audigy 5 EAX Studio, click the Source tab.
2. On the Select Source box, click the source whose effect amount you want to modify.
Repeat Step 2 for as many audio sources as you want to configure.
l
You can test the effect on the Audio source and change its amount, see
l
Audio Effects
3. When you are satisfied with the configuration, save the settings into the current audio effect or, the
factory audio effect.
To save the settings as a new audio effect:
i. Type a new name or the name of an existing user-defined audio effect in the bottom box
on the Audio Effects panel, and then click the Save button.
ii. If you do not want the audio effect anymore, click the Delete button.
Notes
When you select the Always Save Changes Automatically checkbox on the Options page , your
l
revised settings will be saved when you quit from Sound Blaster Audigy 5 EAX Studio. The audio
effect cannot revert to its original settings unless the checkbox is cleared.
You cannot add effects to an audio effect, remove or change their parameters from the Options
l
page. To do so, go to the Master page.
The overall amount settings for effects is a combination of the Master Effects settings and the
l
Source Effects settings.
Settings.
Using Your Sound Blaster Audigy 5 EAX Studio 42
Managing Your