LG GR-642APA Service Manual page 6

2-2 WATER DISPENSER
G Features
DISPENSER
PAD
GRILLE
DRIP TRAY
TAB
HOLE
HOLDER RING
BOTTLE
HOLDER
CONNECTING
PART
WATER TANK
G
Putting The Water In The Water Tank
1. Turn the lock dial in the
direction of the arrow as
shown to remove it and
pour water into the
dispenser water tank.
2. Close the cap by tilting it
and putting one side in first
and then the other side as
shown.
3. Place the water tank in the
tank holder inside the
MOTOR
refrigerator. Make sure that
(INSIDE)
the groove on the connecting
part is in position with the
tab. Push the connecting part
into the hole until it "Clicks".
4. Fix the connecting part in
place by means of the
holder ring as shown.
CAP
CAUTION
LOCK DIAL
1. Do not use anything other than water including soft
drinks, milk and juices.
HANDLE
2. Hot water needs to be cooled before being put in the
water tank.
3. Always use the holder ring to fix the water tank in place
to prevent the tank from moving or getting loose.
WATER TANK
G
Drinking
1 Press the dispenser pad
with the glass.
2 The water is released when
the dispenser pad is
pressed. The pad returns
to its original position when
the glass is removed, and
the water stops its flow.
NOTE
1. The lamp is lit when the dispenser pad is pressed
and the water is released. This makes it possible to
see the water level in the dark.
2. The motor rotates in reverse for a few seconds after
the dispenser is released to dispose of any water
remaining in the tubes. (This may cause the sound
of water being sucked back inside)
- 6 -
Tab
Groove