Winding A Bobbin - Singer S16 Instruction Manual

Winding a Bobbin

w
c
e
y
v
b
n
x
z
r
t
u
i
q
Pull the thread guide bar up as
far as it will go. Stoppers will
click when fully extended.
q Thread guides
w Bobbin winding tension disk
e Bobbin hole
r Notch
t Spring
y Bobbin winder spindle
u Bobbin winder lever/stopper
Step z
Pass the thread through the thread
guides q from behind.
Step x
Pass the thread under the bobbin winding
tension disk clockwise. w.
Step c
Thread through the hole e in the bobbin from
the inside to the outside.
Match the notch r with the spring t on the
bobbin winder spindle. Then insert the bobbin
on the bobbin winder spindle y.
Step v
Push the bobbin winder lever/stopper to
the left u.
Step b
Hold the free end of the thread in your hand
and press the bobbin winding button i. Press
the bobbin winding button again to stop the
bobbin when it has made several turns, and cut
the thread close to the hole on top of the bobbin.
Step n
Press the bobbin winding button again. When
the bobbin is fully wound, the machine will stop
automatically. Return the bobbin winder
lever/stopper to its original position.
Cut the thread with a scissors. Remove
the bobbin from the bobbin winder spindle.
This machine has an independent motor
for bobbin winding. Bobbins can be wound
while sewing.
10
Stopper