Setting Up The Environment
The following are the steps required to set up your PowerVault NX3600/NX3610 NAS Appliance. For more information on
each of the steps, see the relevant sections mentioned in the procedure below.
Figure 1. NAS Appliance – Hardware Overview
1.
Choose the switch topology.
For more information see,
2.
Complete the setting up of your NAS controller(s) in the rack.
For more information, see the Rack Installation document that was shipped with your system.
3.
If required, complete the setting up of your MD storage array(s) and connect the storage array(s) to the NAS
controller(s).
For more information, see the Deployment Guide specific to the MD storage array at dell.com/support/manuals.
Choosing The Switch
Topology.
2
7