Westpoint WI-0035 User Manual page 5

Adjust TIME / TEMP with down arrow or adjust
1) Plug the power cord directly into a conventional 120V 15 amp outlet and press the MASTER
POWER switch on the rear of the portable heater. Then press the POWER button on the front
control panel or on the remote to start the unit. The LED display will show the default value as
0 0
72 F/22 C.
F
(Note: If the ambient temperature (the temperature in the area around the heater) is greater than the set
temperature, the HI/LOW display, fan, and Quartz Bulbs will not operate.)
2) By pressing the
Celsius and vice versa.
3) By pressing the TIME button, the LED display will switch from the temperature status to the TIME
status and begin to flash. The default time will display "--". This means that the TIME is not
activated and, therefore, the heater will remain on. You must press the HI/LOW/UP button or the
0 0
C/ F/DOWN once again within (5) seconds to set the time. Each time you press the HI/LOW/UP
button, the time will increase by 0.5 Hr. If you press the
decrease by 0.5 Hr. The maximum value for time is 8.0 Hr. By holding down the HI/LOW/UP
0 0
button or C/ F/DOWN for (2) seconds, the number rotation will cycle more quickly. If you do not
press the HI/LOW/UP button or
to the temperature status.
0 0
C/ F/Down button, you can switch the temperature format from Fahrenheit to
Press the
switch from Fahrenheit
to Celsius.
0 0
C/ F/DOWN within (5) seconds, the time status will switch back
Press TIME to switch
to time status, then
press HI/LOW/UP
button once within 5
seconds to scroll up
0
C/
Function Display
0 0
C/ F/Down to
0 0
C/ F/DOWN button, the time will
5
0
F settings.