SET-UP
2. Pull the clutch cable enough
to insert the "Z" fitting on the
cable through the auger clutch
lever as shown here. Check
the lever as shown on page .
3. Install the starter bracket using the hardware removed from step 2
on the previous page. For the HS520AS, snap the starter rope into
the rope guide on the handlebar and install the two cable ties. Trim
the cable ties to a length of 3/8 inch (10 mm).
HS520A
CURVED
HEAD BOLT
FLANGE NUT
40
STARTER
AUGER
CLUTCH
LEVER
"Z" FITTING
HS520AS
FLANGE
NUT
ELECTRIC
STARTER
BRACKET
CURVED
HEAD BOLT
ROPE GUIDE
CABLE TIE (2)