Honda Harmony HS520A Owner's Manual page 32

SERVICING YOUR HONDA SNOWTHROWER
A replacement scraper bar may be
purchased from a servicing Honda
snowthrower dealer. See page49
for a part number list.
4. Measure the distance between the
ground and lowest point on the
rubber paddle on the auger.
PADDLE GROUND CLEARANCE: 1/16 ~ 1/8 inch (1 ~ 3 mm)
Adjustment/Replacement
1. Loosen (don't remove) the three
hex nuts on the scraper bar.
2. Move the scraper bar down
slightly. Tighten the self-locking
nuts and recheck the clearance.
Repeat the procedure as needed
to get the necessary clearance. If
you can't get the spacing within
specification, replace the scraper
bar.
CARRIAGE BOLT (3)
SCRAPER BAR
SCRAPER BAR
FLAT WASHER (3)
HEX NUT (3)
A new scraper bar may be purchased from a servicing Honda
snowblower dealer. See page49 for scraper bar and hardware part
numbers.
30
1/16 ~ 1/8 inch
(1 ~ 3mm)
CARRIAGE BOLT (3)
SCRAPER BAR
Adjust position as required.
HEX NUT (3)