SWR Baby Blue II Owner's Manual page 5

CABINET/SPEAKERS
Dimensions
14.5" wide X 24.5" High X 12.5" Deep
Weight
42 lbs.
Total Impedance
4 ohms
8" Loudspeaker
Low resonance
1.5" voice coil
30 oz. magnet
60 watts continuous sine wave power handling capacity
Shallow cone design for low distortion
Impedance: 8 ohms
5" Cone Tweeter
1" voice coil
cast frame
12 oz magnet
50 watts continuous sine wave power handling capacity
Impedance: 8 ohms
Passive Crossover Components
Capacitors: polyester
Coils: 1.7 milli-henry iron choke, low DCR, custom made
Cabinet Construction
Interlocking dado, glued and nailed Cabinet Material: 7 ply, 3/4", waterproof, void free, birch or maple
plywood
Covering: blue carpet
BABY BLUE II - FRONT PANEL FEATURES BABY BLUE II - FRONT PANEL FEATURES
PASSIVE/ACTIVE
This input can and should be used if your instrument has passive electronics (no built-in preamp). Some p
ickups such as EMG, etc. employ batteries for operation and will work perfectly using the Passive/Active input.
Technically speaking, this input should be used if your instrument has an output voltage of 1 volt RMS or
LESS. Consult your owners manual or ask the manufacturer if you are unsure.
NOTE: If you hear a small amount of distortion and neither the Preamp Clip LED or Power Amp clip LED are
activated, try using the Active Input Jack. Some built-in preamps such as those made by Bartolini can be
used in the Passive/Active input.
BABY BLUE II OWNER'S MANUAL • 3