Honda EM1600X Owner's Manual page 14

AC applications
1. Start the engine and make sure the pilot lamp comes on. If not, check the
filament.
2. Switch on the AC Circuit Breaker.
NOTE: Although voltage adjustment is usually not required, fine adjust-
ments may be made by turning the voltage adjustment knob. Use the
generator at the specified voltage (12OV).
3. Plug in the appliance; always three-pronged plugs,
CAUTION: Be sure that appliances do not exceed the generator's rated
load capacity for more than 30 minutes and that they never exceed the
maximum load capacity. Substantial overloading will switch off the circuit
breaker. Marginal overloading may not switch off the circuit breaker, but
it will shorten the service life of the generator.
Be sure that all appliances are in good working order before connecting
them to the generator. If an appliance begins to operate abnormally,
becomes sluggish, or stops suddenly, turn off the circuit breaker and the
generator engine switch immediately. Then disconnect the appliance and
examine it for signs of malfunction.
NOTE: If an overloaded circuit causes the AC circuit breaker to switch
off, reduce the electrical load on the circuit and wait a few minutes before
resetting the circuit breaker.
VOLT METER
AC CIRCUIT
-+f
!
BREAKER
, PILOT
I
I
LAMP
' ~V~L~GE
ADJUSTMENT KNOB\
)
12