Preparation - Honda WB 15 Owner's Manual

3. PREPARATION
1. Suction hose
Use a commercially available hose, hose connector, and hose bands.
The suction hose must be of reinforced, noncollapsible wall or wire
braided hose to prevent suction collapse. The suction hose length
should not be longer than necessary, as the pump performance is best
when the pump is not far above the water level. Self-priming time is
also proportional to the suction hose length. Using a longer suction
hose will increase the self-priming time.
The strainer is provided with the pump and should be attached to the
end of the suction hose with a band as shown.
[I
Always install the strainer on the end of the suction hose before
pumping. The strainer will prevent debris from entering the pump
that can cause clogging or pump damage.
SUCTION HOSE
STRAINER (OPTION)
2. Discharge hose
Use a commercially available hose, hose connector, and hose band. A
short, large-diameter hose is most efficient. A long or small-diameter
hose increases fluid friction and reduces pump output.
Tighten the hose band securely to prevent the hose from
disconnecting under high pressure.
I I
DISCHARGE HOSE
HOSE BAND
6