Table of Contents
Advertisement
INSTALLING FRONT TENSIONER BRACKET
NOTE: Some tractors may already have pulley and
front tensioner guard installed. If not installed, the
front pulley, tensioner guard and front hitch pivots
come as spare parts with the tractor. Locate them
before beginning assembly. if already installed,
proceed to installation of front tensioner.
1. Remove and retain the lower front PTO cover by
removing the six 8 x 16 flange bolts.
2. Install the drive pulley (comes with tractor) on
the front PTO shaft using special 8 x 20 mm
flange (shouldered) bolt. Tighten the bolt to
2.2 kg-m (16 &lb).
3. Position the front tensloner bracket on the frame
beneath the front PTO. Install left side (from
operator's point of view) using two 8 x 16 mm
flange bolts removed from lower PTO cover.
Install right side with two 8 x 16 mm knock bolts
(special stepped flange bolt). Tighten to
2.2 kg-m (16 ft-lb).
Advertisement
Table of Contents
