Tire Inflator Kit Storage - Chevrolet SSR 2004 Owner's Manual

ofrecido por www.electromanuales.com
9. Drive the vehicle immediately to distribute the tire
sealant evenly inside the tire.
10. After driving for 10 minutes, recheck the tire
pressure. If the tire pressure is 19 psi (131 kPa) or
more, inflate the tire to the standard operating
pressure as shown on the Certification/Tire label
located on the edge of the driver's door.
If the tire pressure has dropped below
19 psi (131 kPa), do not continue to drive the
vehicle. The tire is severely damaged and the tire
sealant will not be effective. Repair or replace
the tire as soon as possible.
Tire Inflator Kit Storage
The tire inflator kit is stored behind the driver's seat in
your vehicle. To reinstall the kit after use, do the
following:
CAUTION:
{
Storing the tire inflator kit or other equipment in
the passenger compartment of the vehicle could
cause injury. In a sudden stop or collision,
loose equipment could strike someone. Store
the tire inflator kit in the proper place.
1. Place the air compressor pump and accessories
into the inflator kit case.
2. Move the driver's seat forward and tilt the seatback
forward out of the way.
3. Place the cover over the tire inflator kit.
4. Hold the kit with the cover on against the back wall
of the passenger compartment in the designated
storage area as you perform the next step.
5. Reinstall the two nuts holding the tire inflator kit
cover in place.
5-73