Troubleshooting - Farenheit Mobile Video System Owner's Manual

TROUBLE SHOOTING
If any of problem persists after checking the below list, Please consult your nearest
service dealer. Never attempt to disassemble and repair unit personally.
Problem
Yellow wire not connected or
incorrect
voltage Re wire not connected
or incorrect
Unit will not
voltage
turn on
Black wire not connected
(no power)
ACC Fuse blown or Car battery
fuse blown
Illegal operation
Speaker wires not connected
Unit has
One or more speaker wires
power
touching each other or touching
(but no/low
chassis ground
audio output)
Speakers damaged
Speaker power rating not
Poor sound
compatible with unit
quality or
distortion Speaker is shorted
Unit resets
Incorrect connection between
itself when
ACC and Positive battery wire
engine is off
Yellow or red wire touching
chassis ground
Unit blows
Speaker wires touching chassis
fuse
ground
Incorrect fuse rating
Unit has Parking brake safety circuit not
audio connected
(when in
Parking brake not applied
reverse)
Unit is not mounted correctly
Excessive
skipping
Physical defect in media
IR remote
Dead battery
does not
Battery installed incorrectly
work
Auto antenna is not fully
extended
Weak station
Auto antenna not properly
searching
connected
LOCAL function is activated
Cause
GENERAL
Check connections for proper
voltage(11-16vdc)
Check connection to ground
Install new fuse with correct rating
Press the RESET button
Check connections at speakers
Insulate all bare speaker wires from
each other and chassis ground
Review wiring diagram and check
Connect proper speakers
Check speaker wire contact
Check wiring and correct
Check for pinched wire
Check for pinched wire
Use fuse with correct rating
Check connections at parking brake
Apply parking brake
Check mounting sleeve
Check media for scratches
Replace battery
Remove battery and install correctly
TUNER
Connect the auto antenna control
cable properly
Connect the auto antenna control
cable properly
Turn LOCAL function off
- 50 -
Action