Table of Contents
Advertisement
D-Link DFM-562IS HSFi PCI Modem
ONLY CONNECT EQUIPMENT WITH A TELECOMMUNICATIONS
FOR SAFETY REASONS, ONLY CONNECT EQUIPMENT WITH A
TELECOMMUNICATIOS COMPLIANCE LABEL. THIS INCLUDES
CUSTOMER EQUIPMENT PREVIOUSLY LABELLED
Modems connected to the Australian telecommunications network must be marked in
accordance with the Labeling Notice. This modem has been specifically configured to ensure
compliance with the ACA Standards. Do not adjust your modem or software outside the
values indicated as below. To do so would result in your modem being operated in a
non-compliant manner.
Modem Commands:
Command
Default
ATA
-
ATB
B0
AT&G
&G0
AT&P
&P0
ATSn
see table below
S register
Default
s6
2
Call Attempts/Retries:
Applications software shall be configured so that no more than 3 attempts are made to
establish a connection to a given number (Note: if the modem can detect service tones, up to
10 attempts can be made). If the call sequence is unsuccessful, there shall be a delay of at
least 30 minutes before attempting to call the number again.
Failure to set the modem and any application software used with the modem, to the values
shown as above will result in the modem being operated in a non-compliant manner.
Consequently, this would be in violation of the Labeling Notice for this equipment, and the
Telecommunications ACT 1997 prescribes penalties for the connection of non-compliant
equipment.
WARNING
COMPLIANCE LABEL
WARNING
PERMITTED OR CERTIFIED.
Permissible Range
Do not use
Do not set to B1
&G2
&P1
Permissible Range
2 to 6
3
User's Guide
Advertisement
Table of Contents
