Power Supply PWB Test (1
ST
Test All But Backlights)
Power Supply PWB Test (1
ST
Test All But Backlights)
P2 Connector disconnected from the Main PWB
AC: Not applied when adding jumpers. Applied when making test.
The Power Supply "MUST" be producing STAND-BY +5V and AC Det.
(1) Short either pin 9, 10, 11 or 12 (5V) to Pin 19 (PWR) using a 10K resistor.
(2) Apply AC to the PWB.
This turns on the power supply except for the Ballast Section.
Check the following:
Pins 1 and 2 for +16V
Pins 5 and 6 for +12V
LCD DV
42LG60
27