Table of Contents
Advertisement
COMPUTER INPUT
This projector can automatically detect display signals from most personal computers currently distributed. However, some
computers employ special signal formats which are different from the standard ones and may not be detected by the Multi-
Scan system of this projector. If this happens, the projector can not reproduce a proper image and the image may be
recognized as a flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture.
This projector has a Manual PC Adjustment to enable you to precisely adjust several parameters to match with those special
signal formats. This projector has 5 independent memory areas to memorize those parameters manually adjusted. This
enables you to recall the setting for a specific computer whenever you use it.
Note : This PC ADJUST Menu can not be operated when a digital signal is input to the DVI terminal or "RGB" is selected on
PC SYSTEM MENU (P23).
Press MENU button and ON-SCREEN MENU will appear. Press
1
the POINT LEFT/RIGHT button to move the red frame pointer to
PC ADJUST Menu icon.
2
Press the POINT DOWN button to move the red frame pointer to
the item that you want to adjust and then press SELECT button.
Adjustment dialog box will appear.
LEFT/RIGHT button to adjust value.
Fine sync
Adjusts an image as necessary to eliminate flicker from display.
Press the POINT LEFT/RIGHT button to adjust value.(From 0 to 31.)
Total dots
The number of total dots in one horizontal period. Press the POINT
LEFT/RIGHT button(s) and adjust number to match your PC image.
Horizontal
Adjusts horizontal picture position. Press the POINT LEFT/RIGHT
button(s) to adjust position.
Vertical
Adjusts vertical picture position. Press the POINT LEFT/RIGHT
button(s) to adjust position.
Current mode
Press SELECT button to show information of computer selected.
Clamp
Adjusts clamp position. When image has a dark bar(s), try this
adjustment.
24
MANUAL PC ADJUSTMENT
Press the POINT
PC ADJUST MENU
Move the red frame icon to the item and
press SELECT button.
Selected Mode
Press the POINT LEFT/RIGHT
button to adjust the value.
Press SELECT button at this icon to
adjust "Clamp," "Display area (H/V)" or
set "Full screen."
Current mode
Press SELECT button at
Current mode icon to show
information of computer
connected.
PC ADJUST Menu icon
Shows status
(Stored / Free) of the
selected Mode.
Advertisement
Table of Contents
