Helpful Hints And Tips - Electrolux EWF 87210 W User Manual

10 electrolux
Before you make any change, you must
PAUSE the appliance by pressing the but-
ton 6.
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to O and then to the new pro-
gramme position. Start the new programme
by pressing the button 6 again. The wash-
ing water in the tub will be not emptied out.
INTERRUPTING A PROGRAMME
Press the button 6 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
CANCELLING A PROGRAMME
Turn the selector dial to
gramme which is running.
You can select now a new programme.
OPENING THE DOOR
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button 6. After a
few minutes the light 8.2 goes out and it is
possible to open the door.
If this light remains lit and the door is
locked, this means that the machine is al-
ready heating or that the water level is too
high. In any case, do not try to force the
door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to O. After a
Stand by: once the programme has
finished after a few minutes the energy
saving system is enabled with the pilot

HELPFUL HINTS AND TIPS

SORTING OUT THE LAUNDRY
Follow the wash code symbols on each
garment label and the manufacturer's
washing instructions. Sort the laundry as
follows: whites, coloureds, synthetics, deli-
cates, woollens.
to cancel a pro-
few minutes the door can be opened (pay
attention to the water level and temper-
ature!).
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 6.
AT THE END OF THE PROGRAMME
The machine stops automatically. The pilot
light of button 6, the pilot lights 8.1 and 8.2
go off. The light 8.3 illuminates.
If you have set a programme or an option
that ends with water left in the tub, the pilot
light 8.2 remains on. The door is locked to
indicate that the water must be emptied out
before opening the door. The drum contin-
ues to rotate at regular intervals until the
water draining.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to O.
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
turning the relevant dial.
4. Press button 6.
At the end of the programme, the light 8.2
goes off to indicate that the door can be
now opened. Turn the programme selector
dial to O to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
lights switched on. By pressing any
button the appliance will come out of
the energy saving status.
BEFORE LOADING THE LAUNDRY
Never wash whites and coloureds together.
Whites may lose their «whiteness» in the
wash.
New coloured items may run in the first
wash; they should therefore be washed
separately the first time.
Button up pillowcases, close zip fasteners,
hooks and poppers. Tie any belts or long
tapes.