GE Unitized Electric Washer/Dryer Installation Instructions Manual

Installation
Instructions
Questions on Installation? Call: 1-800-GECARES (US)
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT-
• Save these instructions for
local inspector's use.
IMPORTANT-
• Observe all governing codes
and ordinances.
• Note to Installer -
instructions with the customer.
• Note to Customer - Keep these instructions with
your Owner's Manual for future reference.
discarded, remove the washer and dryer doors.
• Inspect the dryer exhaust outlet and straighten
the outlet walls if they are bent.
• Service information and the wiring diagram are
located at the access panel.
• Do not allow children on or in the appliance.
Close supervision of children is necessary when
the appliance is used near children.
• Install the appliance where the temperature is
above 50°F for satisfactory operation of the
control system.
• Product failure due to improper installation is not
covered under the Warranty.
TOOLS YOU WILL NEED
Slip Pliers
Phillips Screwdriver
1/4" Nutdriver
Level
Printed in Mexico
In Canada, call 800.561.3344 or visit www.GEAppliances.ca
• To reduce the risk of severe injury or death, follow all installation
instructions.
• Install the appliance according to these instructions and in accordance
with local codes.
• This appliance must be exhausted to the outdoors.
• Use only 4" rigid metal ducting for exhausting the clothes dryer to the
outdoors.
• DO NOT
UL listed and installed in accordance with the instructions found
in "Connecting The Dryer To House Vent" on page 8 of this manual.
Flexible venting materials are known to collapse, be easily crushed,
• Do not install or store this appliance in any location where it could be
exposed to water and or weather.
NOTE: Installation and service of this appliance requires basic
mechanical and electrical skills. It is your responsibility to
4" DIA. METAL DUCT
(RECOMMENDED)
4" DIA. FLEXIBLE METAL (SEMI-RIGID)
UL LISTED TRANSITION DUCT
(IF NEEDED)
KIT WX08X10077 (INCLUDES 2 ELBOWS)
4" DIA. FLEXIBLE METAL (FOIL TYPE)
UL LISTED TRANSITION DUCT
(IF NEEDED.)
1 Cable Tie
WARNING:
RISK OF FIRE
MATERIALS YOU WILL NEED
4" DUCT
4" DIA. METAL
CLAMPS (2)
ELBOW
OR
4" SPRING
CLAMPS (2)
DUCT TAPE
4" COVER PLATE (IF NEEDED)
(KIT WE1M454)

PARTS SUPPLIED

2 Rubber Washers
2 Washer Hoses
233D1835P002
Unitized Electric
Washer/Dryer
www.GEAppliances.com (US).
SAFETY
EXHAUST APPLIANCE POWER
GLASSES
HOOD
(NOT PROVIDED)
UL RATED
120/240V,30A
WITH 3 OR 4 PRONGS.
3/4" STRAIN
IDENTIFY THE PLUG
TYPE AS PER THE
RELIEF
GLOVES
HOUSE RECEPTACLE
UL RECOGNIZED
BEFORE PURCHASING
LINE CORD.
2 Stainer Screens/
Rubber Washers
31-16652-5 12-12 GE
CORD KIT