Attaching The Air Purifying Filters - Hitachi RAC-50WPA Manual

ATTACHING THE AIR PURIFYING FILTERS

! CAUTION
Cleaning and maintenance must be carried out when lter lamp lights. Before cleaning, stop operation
and switch off the power supply.
1
Open the front panel
Pull up the front panel by holding it at both sides with
●
both hands.
2
Remove the Pre- lter
Push upward to release the claws and pull out the
●
Pre- lter.
3
Attaching the air purifying lters
Attach the air purifying lters to the frame by gently
●
compress its both sides and release after insertion
into Pre- lter frame.
CAUTION
!
Do not bend the air purifying
lter as it may cause damage
to the structure.
Please do not smell direct from
source of lter.
4
Attach the Pre- lters
Attach the Pre- lters by ensuring that the surface
●
written "FRONT" is facing front.
After attaching the Pre- lters, push the front panel at
●
three arrow portions as shown in gure and close it.
NOTE
In case of removing the air purifying lters, please follow the above procedures.
●
The cooling capacity is slightly weakened and the cooling speed becomes slower when the air purifying
●
lters are used. So, set the fan speed to "HIGH" when using it in this condition.
Air purifying lters are not washable. It is recommended to use vacuum to clean it. It can be use for 1
●
year time. Type number for this air purifying lter is <SPX-CFH22>. Please use this number for ordering
when you want to renew it.
Do not operate the air conditioner without Pre- lter. Dust may enter the air conditioner and fault may
●
occur.
– 9 –