Hitachi RAC-32CNH2 Instruction Manual page 17

2. Washable Suction Grille
The suction grille remove and can wash with clean
water in whole.
Wash it with a soft sponge.
After using neutral detergent, wash thoroughly with
clean water.
When it is not removed, wipe it with a soft dry
cloth. Wipe the remote controller thoroughly with a
soft dry cloth.
Wipe the water thoroughly.
If the water remains at indicators or signal receiver
of indoor unit, it causes trouble.
Method to remove of the suction grille.
Be sure to hold the suction grille with both hands
to detach and attach it.
Removing the Suction Grille
When the suction grille is fully opened with
both hands, push the right arm to the inside
to release it, and while closing the suction
grille slightly, put it out forward.
CAUTION
!
Do not splash or direct water to the body of the unit when cleaning
it as this may cause short circuit.
Never use hot water (above 40°C), benzine, gasoline, acid, thinner or
a brush, because they will damage the plastic surface and the coating.
32CNH2 EN2
Arm
– 17 –
17
Attaching the Suction Grille
Flange
Move the projections of the left and right
arms into the Flanges in the unit and
securely insert them into the holes.
3/25/05, 2:33
Projection
Hole