Beko Dishwasher Instruction Booklet

Beko Dishwasher Instruction Booklet

Dishwasher
Hide thumbs Also See for Dishwasher:

Advertisement

Dishwasher

Advertisement

Table of Contents
loading

Summary of Contents for Beko Dishwasher

  • Page 1 Dishwasher...
  • Page 2 Dear customer, Please read carefully right through this instruction booklet before installing or operating your dishwasher. The following instructions should prevent the risk of personal injury and/or damage to the appliance. Please keep these documents in a safe place for later reference.
  • Page 3: Table Of Contents

    What should not be washed in your Cleaning the spray arms dishwasher 7 Troubleshooting: 3 Directions for Assembly What to do if the dishwasher Safety notes for installation will not run Installing Your Dishwasher The cleaning results are Water connection...
  • Page 4: Getting To Know Your Machine

    Getting To Know Your Machine View of the Machine �� � � �� � � �� � � � � � Upper dish basket with shelf �� Guide rail for the upper dish basket Salt container Cutlery basket Detergent dispenser Door Control panel Filters...
  • Page 5: Safety Instructions

    2006/95/EC: Low Voltage Directive dishwasher@standardloading.com 2004/108/EC: EMV Directive Please do not forget to write the model DIN EN 50242: Electrical dishwasher code and stock code information of for home use Testing procedures for the appliance besides your contact practical service conditions information in the e-mail.
  • Page 6: For Daily Operation

    • Repairs and modifications to the detergent leftovers. appliance may only be carried • The water in the dishwasher is not out by qualified customer service drinking water. Danger of caustic personel. injuries. • In the event of a problem, or before •...
  • Page 7: Directions For Assembly

    • Prior to installing and using your Choose a suitable location for your appliance, please check it for possible dishwasher. Take care to ensure transit damage. that the appliance is stable on a If the appliance is damaged, please level surface.
  • Page 8: Water Connection

    25°C against water damage which may be • caused at the water inlet hose. The dishwasher may not be connected to open warm water Do not immerse the system’s valve devices or flow-through water box into water; it contains electrical heaters.
  • Page 9: Water Drainage

    Water drainage Extension hoses If a hose extension is required, a Connecting the drainage hose. drainage hose of equal quality must be used. Take care to ensure that the drainage hose is not bent or squeezed. The maximum length must not exceed 4m.
  • Page 10: Using Your Dishwasher

    Filling the dishwasher salt Only use special dishwasher salt in Remove the lower basket from the your appliance.The manufacturer is not appliance. liable for damage resulting from the use of the wrong type of salt.
  • Page 11: When Operating For The First Time

    When operating for the first � time: • Pour 1 litre of water into the salt container (Fig. C). • Pour the salt into the container with the aid of the salt funnel provided (Fig. D). • Pour in enough salt to fill the container.
  • Page 12: Filling The Rinse Aid Dispenser

    Filling the Rinse Aid Dispenser Rinse aids allow washing water to rinse off more cleanly and prevent watermarks or streaks on the dishes. Only use rinse aid designed for use in dishwashers. If you use “2 in 1” or “3 in 1“ 1013 �...
  • Page 13: Detergent

    The detergent container holds a total of 40 cm³ of detergent (1). Please use detergents produced specially for the dishwashers in your When the dishwasher is fully loaded machine. and the dishes are very dirty, we recommend filling the detergent Keep the opened detergent container up to the 25 cm³...
  • Page 14: Multipurpose Detergents

    Loading the dishwasher aid and water softening salt. General: 4in1: Those containing glass protectors in addition to detergent, rinse aid and Before you load the dishwasher with water softening salt. dishes • 5in1: Those containing glass and Remove coarse food leftovers •...
  • Page 15: Suggestions For Loading The Dishwasher

    � � dishwasher and pay attention to the notes regarding dishes which are suited to the dishwasher. Only in this manner will you obtain optimal washing results with a sensible use of energy. Start unloading the dishes from the 1017 lower basket, then switch to the upper basket.
  • Page 16 (depends on the model) � There are two separate “folding plate support rods” in the lower basket of your dishwasher designed to allow 1054 you more space to accommodate saucepans and large bowls in the lower basket. You can either fold each section (1, 2) individually or, all at once, to create a large empty space.
  • Page 17 Variable cutlery basket (depends on the model) The variable cutlery basket can be separated into 3 parts depending on the amount of cutlery and the degree of dirtiness. Small cutlery basket sections also fit into the upper basket. � To do this, turn the lock on the handle to the right (A).
  • Page 18 Cutlery Basket Movable Cutlery Basket (depends on the model) (depends on the model) Designed to allow free placement of the dishes according to their size, the movable cutlery basket can slide over the tines to the left (A) and right (B) side.
  • Page 19 Basket insert with variable height settings (depends on the model) You can also use this insert in the lower basket for glasses and long- handled cutlery / utensils. If you do not need the insert, fold the rack upwards at the angle shown (A). Push the entire insert upwards (B).
  • Page 20: Loading Suggestions

    The height of the upper basket was set to its lowest position at the factory.
  • Page 21 1065 without having to remove it from the dishwasher, even if it is fully loaded. � The height of the upper basket was set to its lowest position at the factory.
  • Page 22 Height setting with empty basket (depends on the model) In this model, the height setting of the upper basket may be changed using the wheels which are mounted at two different heights. Release the latches on both the right � and left tracks of the upper basket by pushing them outwards (C).
  • Page 23 Glass Support (depends on the model) When placing the glasses or goblets with a long grip, lean them against the glass support, the edge of the basket or the shelf but not against the other pieces. Do not lean the long glasses against each other, otherwise they do not remain stable during washing cycle and may get damaged.
  • Page 24: Program Selection And Operating Your Machine

    Program Selection and Operating Your Machine � � � � � � � On / Off Button Half Load/Tablet Detergent Button Start/Pause/Cancel Button Delayed Start Button Display Handle Program Selection Button � � �� �� �� �� � � � ��...
  • Page 25: Button And Button Descriptions

    Button and Button programs can change depending on the model you have purchased. Descriptions On / Off Button (1) Half Load / Tablet Detergent Button When you press the On/Off button, the display switches on with the last Half Load / Tablet Detergent Button program used and it dims when you allows you to turn on and off the Half turn the machine off.
  • Page 26: Program Selection

    close the door of your machine. Time indicator (11) will start displaying the estimated remaining time to the To use the Half Load and Tablet end of program. Detergent functions concurrently, turn on your machine by pressing the Total time can be different from On / Off button and then press the the time indicated at the beginning Half Load / Tablet Detergent button...
  • Page 27: Canceling A Program

    Program indicator 15 c lights up when program until 9 hours. Delayed start the program is over. Remaining Time can not be set after the program starts. Indicator (3) displays “0:00”. The selected program must not be started in order to be able to set the Canceling a Program delay time.
  • Page 28: Salt Indicator

    minutes the machine will fulfill the (OFF), rinse aid indicator will never necessary operations required for come on even if the rinse aid cancellation. Remaining time indicator container is empty. (11) displays “0:00”. You may select and operate a new program following Rinse Aid Indicator Setting the delayed start countdown •...
  • Page 29 detergent in the detergent cooled down. Your dishes will dry dispenser and close its lid. in a shorter time if you leave the • Press On/Off button. door of your machine ajar during • Check if the salt and rinse aid this period.
  • Page 30 29 GB...
  • Page 31: How To Clean Your Dishwasher

    How to clean your dishwasher Cleaning your machine at regular intervals ensures longer product life and reduces the risk of reccurring problems. Always unplug the machine and � turn off the water supply before � cleaning. Use a gentle household cleaner for the outside and the door seals.
  • Page 32: Cleaning The Spray Arms

    Cleaning the spray arms Cleaning the filter inset in the water inlet hose (depends on the model) Dirt or calcium residue may block the Dirt from deposits in the water pipes is nozzles on the spray arms. For this prevented by a filter in the water inlet reason, regularly check the spray hose.
  • Page 33: Troubleshooting

    • Is the dishwasher door closed firmly? • Have you pressed the On/Off button? • Is the filter on the water intake and dishwasher clogged? The cleaning results are unsatisfactory 1033 Uncleaned Dishes Disorderly placement Load your dishes as described in the manual.
  • Page 34 Increase rinse aid setting or add rinse aid into rinse aid compartment. Unloading the machine right after dishwashing Do not unload your dishwasher right after washing process is completed. Slightly open the door and wait for evacuation of the inside steam for a while.
  • Page 35 1035 Lime Stains, Hazy Look Inadequate rinse aid Increase rinse aid setting or add rinse aid into rinse aid compartment. Insufficient water softening In products equipped with water softening setting, water softening should be properly set in accordance with the hardness of the supply water. Add salt into the salt container, if necessary.
  • Page 36 Recheck the salt box cover after the program is completed. Grounding line Check if your dishwasher is connected to the actual grounding line. Otherwise, the static electric created in the dishwasher may remove the protective coating on metal surfaces and cause blackening and corruption.
  • Page 37 Connect the drainage hose as described in the manual. Odour Odor of new dishwasher A new dishwasher has a peculiar odor. It will fade out after a couple of washing. Clogged filters From time to time, remove the complete filter system as shown in the manual and wash it under flowing water.
  • Page 38 Leaving the dishes in the dishwasher for a long time If you are not going to run your dishwasher immediately, load the dishes into your machine after scraping the excessive soil on them and do not tightly close the door of the machine. Every other day, perform washing without detergent in the shortest program for products with program selecting feature.
  • Page 39: Service

    Service If your appliance ever malfunctions, check the notes and advice given in the operating manual. If this does not fix the problem, our customer service staff are available to assist you. 38 GB...
  • Page 40 17 7555 01 00-AG-MM...

Table of Contents