Sharp R-4H55 Service Manual page 34

CHOKE
1.
2.
Insert
COVER REMOVAL
an iron plate(thickness of about OSmm) or flat
type screw driver to the gap between the choke cover
and door panel as shown in the figure to free the engag-
ing part.
Lift up the choke cover, now cover is free.
Ii!
FLAT TYPE
l-l
SCREW-DRIVER
PROTECT BY TAPE
Figure C-9. Choke Cover Removal
DOOR PARTS REMOVAL
Remove the door assembly, referring to from item 1
through item 5 of "DOOR REPLACEMENT".
1. Place the door assembly on a soft cloth with latch
heads facing up.
2. Remove the choke cover, referring to "CHOKE COVER
REMOVAL".
LATCH HEAD REMOVAL
3. Lift up the latch head towards the direction that the ar-
4.
row shows in the figure C-10, and release the latch
head from the holes in the door panel
Release the latch spring with the latch head from the
tabs of the door panel.
5. Release the latch spring from the latch head.
6. Now, the latch head is free.
LATCH HEAD RE-INSTALL
1. Pick up the latch spring and catch the one ring of the
latch spring on the tab of the door panel as shown in
Figure C-i 0.
2. Catch the other ring of the latch spring on the tab of the
latch head.
3. Install the latch head to the holes in the door panel.
Door
I
Panel\'* fp
Latch ' '
head
Tab of the door panei
Figure C-10. Latch head removal and reinstall
SEALER FILM
Removal
1. Tear the sealer film from the door panel.
2. Now, the sealer film is free.
Installation
1. Put the adhesivetape on the backing film of the sealer
film.
2. Tear the backing film by pullingthe adhesivetape.
3. Put the pasted side of the sealer film on the door panel.
Sealer film
\
Backing film
/
Sealer film
32