Assembling Your Helio Cycle; Unpacking Your Helio Cycle - Helio Electric Cycle Owner's Manual

Assembling your Helio Cycle

Chances are, you have already assembled your Helio Cycle using the Quick
Assembly Guide. But for completeness, we cover the assembly here as well.
Assembling your Helio Cycle is simple and takes only a few minutes. However, if
you're unsure of your ability to properly assemble your Helio Cycle or simply don't
want to do it yourself, your local bicycle shop might be able to help.
A properly sized allen key and hex wrench are required, so we included these tools in
the box. No other tools are required other than scissors to cut away some of the
packaging straps.
Obviously, it is extremely important that you assemble your Helio Cycle
correctly. If you don't, you may not be able to control your Helio Cycle. An
uncontrollable Helio can cause severe injury or even death, so follow the
procedures carefully.
☺ "If you cannot find the time to do a task correctly, how will you find the
time to do it over?"
Your Helio Cycle was carefully assembled and thoroughly tested for proper
performance at the factory. To facilitate shipping, we removed the handlebar and
front wheel assemblies and the saddle assembly. The front wheel is also removed
from the front fork. To reassemble your Helio Cycle:

Unpacking your Helio Cycle

1. Find a large, clean, flat surface,
like your garage or driveway, to
unpack your Helio Cycle.
2. With the box upright, remove
the strapping material and open
the top of the box. Then open
the ends of the box allowing the
large side panel to fold down to
the ground.
3. Slide the Helio Cycle out of the
box onto the open cardboard
panel. Locate the small box
with parts inside. Inside you
will find some small parts and the tools needed for assembly.
4. Cut away the plastic tie wraps and remove the packaging material.
- unknown
Page 13
Red Tape